Basic cleaning of porcelain stoneware in seven steps – the instructions for perfect cleaning results

In this article you will learn how to make your porcelain stoneware flooring look like new in 7 easy steps

1. Sweep

Remove loose dirt by sweeping or vacuuming.

Tip:Use sweepers to raise less dust.
Basic cleaning: Step 1 - sweeping Basic cleaning: Step 1 - sweeping

2. Submit cleaning liquor

Depending on the degree of soiling, mix haid-tec® Fine Stoneware Cleaner in a ratio of 1:3 to 1:10 or haid-tec® Basic Cleaner alkaline in a ratio of 1:1 to 1:5 with water.

Apply the cleaning solution thinly in sections with the mop.

Tip:You have applied the correct amount of cleaning liquor, when a match floats on the liquid film.
Basic cleaning: Step 2 - present Basic cleaning: Step 2 - present

3. Reaction time

Allow the cleaning liquor to react for 3 – 10 minutes. The cleaning liquor must not be allowed to dry. Rewet the areas that have dried.

Tip:Increase the exposure time when it is cold. The cleansing active substances react more slowly when it is cold.
Basic cleaning: Step 3 - Reaction Basic cleaning: Step 3 - Reaction

4. Finish the surface with MelaminPlusPads

Equip the scrubber-dryer with MelaminPlusPads. Sweep the area slowly without suction. Or work the floor covering with the single-disc machine with MelaminPlusPads heavily overlapping.

Tip:With cleaning liquor in the tank, you can re-wet drying areas if necessary.
Basic cleaning: Step 4 - MelaminePlusPad scrubber-dryer Basic cleaning: Step 4 - MelaminePlusPad scrubber-dryer
Basic cleaning: Step 4 - MelaminePlusPad single-disc machine Basic cleaning: Step 4 - MelaminePlusPad single-disc machine

5. Pick up dirt liquor

Pick up the dirt liquor with the wet vacuum cleaner or the scrubber dryer.

Tip:With the scrubber-dryer, you can take care of the next step right away.
Basic cleaning: Step 5 - Absorbing the dirt liquor Basic cleaning: Step 5 - Absorbing the dirt liquor

6. Clear rinse

Wipe the floor covering with clear water at least twice or run the scrubber dryer over the floor covering with a large overlap. This neutralises the floor covering and removes cleaning agent residues.

7. Observe drying time

Allow the floor covering to dry completely before walking on it to prevent resoiling.

Tip:When using a scrubber dryer, the floor covering dries much faster.
Basic cleaning: Step 7 - Let the floor dry Basic cleaning: Step 7 - Let the floor dry

Summary

If you carry out the basic cleaning according to these simple step-by-step instructions, you can achieve the best possible cleaning result in a short time and your porcelain stoneware floor will look like new again.

Comments are closed.

online shop